Albi Manufacturing
East Berlin, Connecticut

860.828.0571 Phone

860.828.3297 Fax



Albi Clad 800 Application Tools

Application of Albi Clad 800 requires the following tools:
1.  Graco 10:1 President Pump with:

  • Leather Packings
  • Evenflo Regulator

2.  50 feet of 3/8 inch air hose

3.  3/4 inch solvent resistant flexible hose not to exceed 1000 psi

4.  Binks 7E2 Spray Gun with 3/4 inch swivel or Graco Mastic Spray Gun with 3/4 inch swivel

5.  45 x 1/4 inch tip


Albi Clad 800 Surface Preparation:
-Interior as per SSPC-SP2 or SP3
-Exterior requires a minimum of SSPC-SP6 commercial blast

•Albi Manufacturing recommends that application be performed with the use of a pneumatic pump designed for application of heavy-duty, viscous materials and a heavy-duty, mastic spray gun. Compressor shall provide at least 80 CFM (2.3m3/min.) of air at 100 PSI (7 kg/cm2). Material hose must be 3/4” (19.1 mm) I.D. Nylon or other corrosive resistant type suitable for strong solvents. Gun shall have minimum 3/4” (19.1mm) material inlet and 3/8” (9.5mm) air inlet ports.

•All surfaces shall be rolled prior to drying of surface film in order to remove unsightly drippings or surface irregularity.

•Small patchwork or damaged areas may be hand-troweled or gloved. When hand troweling, tools must be kept wet with Albi Clad solvent in order to avoid sticking


Albi Clad 800 Application ToolsGraco President Pump        Fire Resistant Paints   


Fireproofing Companies   Albi Clad Solvent   

Return To Albi Clad 800 Page